“H” CLASS Refuse Drag Chains (H102/H104/H110/H112/H116/H120/H480)

“H” CLASS Refuse Drag Chains can be used for conveying sawdust,wooden chips, pulp, garbage, tankage, ashes, and other abrasive spend through either wooden or steel troughs. Due to its large, wide opening area, “H” CLASS Refuse Drag Chain provides sizeable "H" CLASS Refuse Drag Chains (H102/H104/H110/H112/H116/H120/H480) - h class refuse drag chain21230553120having capacity when managed at moderate speeds.
The front face of each barrel is flat, providing a broad area to push material along the trough and to keep the chaim from riding over the top of the material. The rounded inner aspect of the barrel is carefully shaped to create excellent sprocket get in touch with. Sidebars are reinforced with Drive Chain putting on shoes which provide both
additional wearing surface and stiffening for the link. A vertical member on each sidebar assures added link rigidity and shields the pin from harm.
“H”CLASS Refuse Drag Chain comes in EVRT-POWER Promal or Duramal with a tensile strength range of 36,400 to 52,000 pounds. This rugged working chain comes in a pitch range of 5.000 to 8.000 inches. Each link is produced in accordance with manufacturer’s specifications and may be interchanged with links made by other chain producers. “H”CLASS Refuse Drag Chain is available in riveted construction just. Grease chambers, cored into each link’s barrel, keep grease which lubricates pins.
Wide faced sprockets, either of machined or cast steel, are recommended for”H” course Refuse Drag Chain operation. Links should be run in direction of the closed barrel.

Pin It on Pinterest

Share This